IC 155 Crystalina Shimmer
Add some bling to your print without the bother of rhinestones
Tip - remember, shimmer and glitter inks require a lower, more open screen mesh. For the Crystalina, a 40 screen mesh is recommended. Click HERE to purchase a 40 mesh screen.
Here is a link to our Screen Mesh Chart. Hopefully this will assist you in choosing the correct mesh for your print job.
International Coatings Shimmer Plastisols are press ready. They provide a bright, non-tarnishing metallic sparkle to printed garments. The inks consist of a fine, shimmering glitter flake in a low bleed, low fusion, easy to print base. This is a real plus for hand and automatic printers, when it comes to wear and tear on people and equipment.
100% Cotton and some cotton/polyester blends. Always test print fabric before beginning a production run.
155LF METALLIC SHIMMER should be printed onto garment right from the container without any modifications. Thinning this product may reduce the metallic sparkle. If modification is necessary use the following reducers:
DARK GARMENTS: Use 1099LF Low Bleed Curable Reducer (Add 1% to 10% by Volume).
LIGHT GARMENTS: Use 1110LF Curable or 1099LF Low Bleed Curable Reducer (Add 1% to 10% by Volume
50 - 61 t/in or 20 - 24 t/cm Monofilament
60-70 Durometer: Sharp edge for light colored fabrics and beveled or sharp edge for dark fabrics.
325°F (163°C) entire ink film. Test dryer temperatures before a production run. Wash test printed product before beginning production run.
Mineral spirits or any environmentally friendly plastisol screen wash.
STORAGE OF INK
Recommend storage at 65°F to 90°F (18°C to 32°C). Avoid storage in CONTAINERS direct sunlight and moist, humid air.
|Tech Sheet||Safety Sheet|